Bearing & Separator Spares
08542100 Slide Hammer Assembly - 1kg
For use with Sykes-Pickavant split collet type internal extractors. Hammer displacement: 220mm. Hammer weight: 1kg.
-
09501200 Bolt & Nut
Replacement bolt & nut For 09500000 Separator
-
09511200 Bolt & Nut
Replacement bolt & nut For 09510000 Separator
-
09511570 Separator Jaw (single piece)
Replacement separator jaw (single piece) For 09510000 bearing separator
-
09521200 Bolt & Nut
Replacment bolt & nut For 09520000 separator
-
09521570 Separator Jaw (single piece)
Replacement separator jaw (single piece) For 09520000 bearing separator
-
09580900 Split Collet Extractor 6.5 - 8mm
The split collet is pushed into the centre of the bearing and then expandedvia the hex nut on the end of the collet until a secure grip is achieved.The slide hammer is then attached providing the necessary extracting force.Internal Spread Min - Max: 6.5-8mmNo.00 - stamped on extractor
-
09581000 Split Collet Extractor 8.5 - 10mm
The split collet is pushed into the centre of the bearing and then expandedvia the hex nut on the end of the collet until a secure grip is achieved.The slide hammer is then attached providing the necessary extracting force.Internal Spread Min - Max: 8.5-10mmNo.0 - stamped on extractor
-
09581100 Split Collet Extractor 10 - 12mm
The split collet is pushed into the centre of the bearing and then expandedvia the hex nut on the end of the collet until a secure grip is achieved.The slide hammer is then attached providing the necessary extracting force.Internal Spread Min - Max: 10-12mmNo.1 - stamped on extractor
-
09581200 Split Collet Extractor 12 - 17mm
The split collet is pushed into the centre of the bearing and then expandedvia the hex nut on the end of the collet until a secure grip is achieved.The slide hammer is then attached providing the necessary extracting force.Internal Spread Min - Max: 12-17mmNo.2 - stamped on extractor
-
09581300 Split Collet Extractor 19 - 22mm
The split collet is pushed into the centre of the bearing and then expandedvia the hex nut on the end of the collet until a secure grip is achieved.The slide hammer is then attached providing the necessary extracting force.Internal Spread Min - Max: 19-22mmNo.3 - stamped on extractor
-
09581400 Split Collet Extractor 22 - 30mm
The split collet is pushed into the centre of the bearing and then expandedvia the hex nut on the end of the collet until a secure grip is achieved.The slide hammer is then attached providing the necessary extracting force. Internal Spread Min - Max: 22-30mm No.4 - stamped on extractor
-
09581500 Split Collet Extractor 30 - 38mm
The split collet is pushed into the centre of the bearing and then expandedvia the hex nut on the end of the collet until a secure grip is achieved.The slide hammer is then attached providing the necessary extracting force.Internal Spread Min - Max: 30-38mmNo.5 - stamped on extractor
-
09582000 1/2" Female to M8 male converter
For use with 08542100 Slide Hammer when fitting smaller sized Split Collet Extractors ( 6.5 - 30mm / 09580900 - 09581400 )
