Govoni Diagnostics
GO2100PRO - Multifunctional Tool for Testing Sensor & Actuators 24V
Digital electronic tester for functional checks on car sensors and electromechanical components. Where self-diagnosis stops, it is essential to trace the root of the problem that generated the error code, thanks to SPECTRUM: the analysis of continuous and impulsive signals (pwm) is much simpler than the traditional oscilloscope and the piloting of the electromechanical components allows the operator to immediately check their functionality.
-
GO2115 - Docking Station Spectrum
Docking station for GO2100PRO
-
GO2114 - Diagnostic Can Test
Diagnostic wiring, with the function of analyzing the vehicle's CAN network through the self-diagnosis connector with display of the values and outcome of the test. For use with GO2100PRO
-
GO2113 - OHM Meter Wiring
Acquisition wiring, with resistance detection function for use with GO2100PRO
-
GO2112 - Glow Plug Test Wiring
Emulation wiring, with the glow plug test function with the measurement of the current absorption of the same and display of the tests.
-
GO2111 - Piezo Activator
Module with the function of activating the piezoelectric injectors, connecting to SPECTRUM, then it is recognized and is ready for activation.
-
GO2110 - PWM Signal
Emulation wiring, with the function of generating PWM waveforms with negative ground, for the emulation of sensors with digital output or the control of electronic low power actuators.
-
GO2109 - PWM Power Plus (5 Pin)
Emulation / acquisition wiring, with the function of PWM power generator such as PWM POWER with an integrated 5V voltage generator; mass generator and feedback control. It is used for the activation of the components controlled in feedback through potentiometers.